Cold Room Unit Installation guide in Kenya
Cold Room Unit Installation guide in Kenya guide will provide you with all the necessary information to successfully install a cold room. From understanding the basics to choosing the right location. Professional cold room installation services in Kenya. Reliable commercial refrigeration featuring advanced compressor technology.
Installation requirements for assembled cold room panels
- Check the project design and construction materials list, and carefully check the materials and accessories.
- Before installing, check the number of cold storage panels. When loading and unloading the storage panel, it is necessary to handle it carefully and lay an anti-scratch layer on each of the panels and the ground joint.
- When assembling the cold storage, there should be a gap between the wall and the roof, the ground or the floor must be level, and the construction environment should be clean.
- Before fixing the interior of the storage body with angle aluminum, seal it with glass glue and then fix with angle aluminum by solid pull. The distance between the rivets is 300mm. The distance between the upper and lower sides of the door is 100mm.
Installation requirements for refrigeration units
- The semi-hermetic or hermetic compressor should have an oil separator, and the appropriate amount of oil to live in the oil
division, evaporation temperature below -15 degrees, should have gas-liquid separator and add the appropriate amount of refrigerant oil. - The base of the compressor should have a shock-absorbing rubberseat.
- The installation of the unit should leave room for maintenance, which is convenient for observing the adjustment of instruments and valves.
- The high pressure gauge should install at the tee of the liquid storage filling valve.
- The overall layout of the unit is reasonable and the color is consistent. The installation structure of each model unit should be consistent.
Technical requirements for the installation of unit coolers
- When choosing the location of the hanging point, first consider the location of the best air circulation. Secondly, in considering the direction of the structure of the cold room
- The gap between the evaporator and the panels should be greater than the thickness of the evaporator.
- All suspension bolts of the unit cooler should be tight. And use sealant to close the bolts and suspension bolt perforations to prevent cold bridges and air leakage.
- When the ceiling-type evaporator is too heavy, apply No.4 or No.5 angle iron to make a cross-beam.
Installation requirements for refrigeration pipelines
- The diameter of the copper pipe should be selected in strict accordance with the suction and discharge valve interface of the compressor. When the condenser and compressor separation of more than 3 meters should increase the diameter of the pipeline;
- The condenser suction surface and the wall to maintain more than 400mm distance. The outlet and obstacles to maintain a distance of more than 3 meters;
- The inlet and outlet pipe diameters of the liquid storage tank shall be subject to the exhaust and liquid outlet pipe diameters marked on the unit sample.
Power Distribution System Installation Requirements
- Each contact needs to be equipped with a line number for maintenance;
- Make the electric control box in strict accordance with the requirements of the drawings, and connect the electricity to do the no-load test;
- Mark the name on each contactor;
- Fix each electrical component wire with binding wire;
- The electrical contacts should be pressed tightly to the wire joints, and the main wire joints of the motor should be clamped tightly with wire clips, and tinned if necessary;
Conclusion: Cold Room Unit Installation guide
Installing a cold room involves careful planning, attention to detail, and adherence to safety standards. By understanding the fundamental aspects of the installation process, choosing the right components, and seeking professional assistance when necessary, you can create a functional and efficient cold room that meets your specific needs. Remember to prioritize regular maintenance and monitoring to ensure optimal performance and longevity
